Electronic Circuit Board Cloning Service

Electronic Circuit Board Cloning Service, is a most basic type of ELECTRONIC CIRCUIT BOARD, all of the components will be concentrated on the side, and all of them will focus on other side of the electronic PCB board.

Because all of the circuit track pattern will emphasis on the same side, we normally call this electronic circuit card as single sided PCBA reverse engineering.

When cloning single side ELECTRONIC CIRCUIT BOARD, there are a lot of restrictions, since the electronic circuit board has only one side, and there is no crossing line is allowed so each one of the tracks should go the isolated route;

Double layer printed circuit board Clone procedure

When cloning double side electronic circuit board, due to there are layout tracks on both side of this PCB board, so it is necessary to electrical connect the both sides of the tracks. Engineer will use VIA to connect them, VIA is a small drilling hole on the PCB card which is filled with the metal foil which make the top side and bottom of electronic circuit board electrically connected after cloning and manufacturing.

Since the double side electronic PCB has double the layout area than single sided circuit board, so it is more suitable for more complicate PCB card cloning;

Tags: pcb assemble duplicating,pcb board duplicating,pcb card duplicating,pcb duplicating,pcba duplicating,printed circuit board duplicating,printed wiring board duplicating,pwb duplicating,pwba duplicating