pcb assemble clone
-
PCB Clone Accuracy
PCB Clone Accuracy As we all know, PCB Clone Accuracy depends on the preciseness of image scanning, so high DPI makes lots of sense in the scanning image, but DPI can’t set too high to undertake by computer because the higher the DPI value, the large...
-
Printed Circuit Board Clone Inspection
After Printed Circuit Board Clone process done, engineer need to inspect the work done, as we all know, electrical characteristic of Printed Circuit Board is always the most critical aspects, so below items refers to its electrical characteristic mus...
-
PWB Reverse Engineering Consider EMC’s Grounding Kill
PWB Reverse engineering Consider EMC’s Grounding Kill In the PWB reverse engineering, grounding is a very important measure to prevent the noise and prohibit the interference. The grounding method should be different due to the variation of circuit, ...
-
Printed Circuit Board Reverse Engineering Defect
Both Printed Circuit Board and component will have bow and twist after manufacturing, due to stress distortion cause cold soldering and short circuit. Bow and twist of printed wiring board are normally caused by the imbalance heating. For large print...
-
Printed Wiring Board Clone Defects
Printed Wiring Board Clone Defects can be caused by several reasons, hereby we would like to introduce several reasons: The solderability of printed wiring board hole will affect the PCB cloning quality, if the holes don’t have a good solderability, ...
