Cloning Electronic PCB Card

Cloning Electronic PCB Card means the original printed circuit board can be remanufactured through the extracted layout drawing, Gerber file and BOM, schematic diagram, engineer need to insert the electronic components onto the Electronic pcb cards.

Cloning Electronic PCB Card means the original printed circuit board can be remanufactured through the extracted layout drawing, Gerber file and BOM, schematic diagram, engineer need to insert the electronic components onto the Electronic pcb cards
Cloning Electronic PCB Card means the original printed circuit board can be remanufactured through the extracted layout drawing, Gerber file and BOM, schematic diagram, engineer need to insert the electronic components onto the Electronic pcb cards

first install the components on one side of Electronic pcb card , then solder their leads on the other side of the Electronic pcb card . this technology is called through hole technology package. However, this soldering method will consume great amount of space,

and it is required to drill each one of the holes by manufacturer for the components lead and give rise to the Electronic pcb card fabrication cost. As a result of that, this method will occupy both sides of the spaces on the Electronic pcb card with soldering point on the soldering side.

However, from the other side, THT components normally have a better connection and solder reliability than surface mounted technology. Such as the wire assembly, till now over 90% of them are all packed by THT method due to the pressure resistance test and requirement.

Surface mounted technology is the most populated way in the Electronic pcb board manufacturing, if you choose to use SMT to solder the component on the PCB board, and all of the components will be mounted on the same side of Electronic pcb card , furthermore, it is no necessary to drill the hole on the Electronic pcb card for each lead of components. And these SMD can even be mounted on both sides of Electronic pcb card to save more space.

SMT parts have much smaller size than the THT parts, compare with the THT part obtained from reverse engineering pcb card documents, SMT assemble part has cheaper price and more dense. So it makes a lot of sense to use SMD to replace THT insert part in recent electronic industry. Since both the soldering point and pinout on the components are all very small, so it is quite difficult to solder them by hand. However, considering all of the Electronic pcb card assemble are all automatically, this issue will only occur in the prototype building and repair process.


Tags: ,,,,,,,,,,